if it's not working, move the liveboxTV on ETH1 and edit your config and do not connect the controller
Ok, I now have everything working and the LiveboxTV is in the living room now
I really don't know how it is working haha! I think it is magic! I will post both the config.gateway.json and config.boot below.
My config.gateway.json file is a bit messy since its using the generated file from this post:
https://www.choiz.fr/2017-08-26-remplacer-sa-livebox-par-un-unifi-security-gateway-3p-(usg).html. The IPv6 isn't working either.
So now, my goals (now that both internet and tv are working), are:
1) Go in to go in the existing config.gateway.json file and try to remove what I do not need (so the file is cleaner).
2) Try to get IPv6 working by copying your config.gateway.json file you provided in a previous post.
If you have any suggestions on how I might be able to get the IPv6 working, that would be amazing
Before now, I would always use your config.gateway.json for my IPv6 + internet, and it always worked. So if there is a possibility to implement your config.gateway.json file into the existing one I have now, everything would be perfect.
If it helps other members of the forum, I can take pictures of my setup and fully document the steps I took to get the TV and internet working consistently. I would really like to clean up the .json file and get IPv6 working before that (so less confusion for other members).
I will try to reach out to the creator of that blog post and see if he has any suggestions.