Depuis mon routeur openwrt : ethtool -m eth1
eth1 étant le port dans lequelle est inséré l'ONU
parmis toutes les lignes affichées, tu devrais avoir celles-ci
Optical diagnostics support : Yes
Laser bias current : 10.398 mA
Laser output power : 1.4911 mW / 1.74 dBm
Receiver signal average optical power : 0.0187 mW / -17.28 dBm
Module temperature : 46.27 degrees C / 115.28 degrees F
Module voltage : 3.3234 V
directement depuis l'ONU avec un firmware fs.com : otop -g s
chip version (fuse format) A22 (1)
driver version (otop version) 7.5.1 (7.5.1.0)
state history 9 8 4 3 2 1 6 0 0 0
config reads + + + + + + + +
table reads + + + + +
PLL lock status locked
Signal detect true
manage mode (OMU/BOSA/BOSA2), powerlevel BOSA, normal (0)
manual mode, BERT mode, BOSA loop mode off, off, dual-loop
laser age (active time) 15:47:58
laser temperature (ext corr): 324K
die temperature (int corr) 343K
rx offset correction -21
maximum bias / modulation current (chip) 78.00mA / 95.00mA
precalc. bias / modulation current 12.40mA / 27.41mA (6)
actual bias / modulation current 11.04mA / 24.40mA
bias / modulation change (errors) stable / stable (0 / 0)
integration coefficient bias / modulation 7 / 7
gain correction factor P0 / P1 0.91 / 0.91
MPD target P0 / P1 +91 / +635
MPD actual P0 / P1 (variation to target) n/a
current offset 157.35uA
RSSI 1490 voltage, current 113.40mV 161.99uA
RSSI 1550 voltage 496.70mV
RF 1550 voltage 497.07mV
DDMI voltage 3318.85mV
RSSI 1490 power 18.18uW -17.29dBm
tx power (se*(bias+mod/2-ith)) 1.45mW 1.61dBm
precalc. dcdc apd voltage, saturation 40.61V 161 (4)
DCDC APD target voltage (active/inactive) 40.61V (active)
DCDC APD voltage (regulation error), saturation 40.67V (-0.06V) 161
linear LDO converter (active/inactive) (inactive)
Remplacer la box SFR par un routeur