Pour interroger le driver pour avoir le Tx Rx, c'est quelle commande ?
Il ne donne pas l'info dans dmesg :
[ 13.348951] ixgbe 0000:01:00.0 p1p1: detected SFP+: 5
[ 13.612919] ixgbe 0000:01:00.0 p1p1: NIC Link is Up 10 Gbps, Flow Control: RX/TX
$ dmesg | grep ixgbe
[ 3.830581] ixgbe: Intel(R) 10 Gigabit PCI Express Network Driver - version 4.4.0-k
[ 3.845432] ixgbe: Copyright (c) 1999-2016 Intel Corporation.
[ 4.016955] ixgbe 0000:01:00.0: Multiqueue Enabled: Rx Queue count = 8, Tx Queue count = 8
[ 4.017156] ixgbe 0000:01:00.0: PCI Express bandwidth of 32GT/s available
[ 4.017165] ixgbe 0000:01:00.0: (Speed:5.0GT/s, Width: x8, Encoding Loss:20%)
[ 4.017283] ixgbe 0000:01:00.0: MAC: 2, PHY: 18, SFP+: 5, PBA No: E66560-005
[ 4.017301] ixgbe 0000:01:00.0: 90:e2:ba:19:f7:50
[ 4.032541] ixgbe 0000:01:00.0: Intel(R) 10 Gigabit Network Connection
[ 5.240424] ixgbe 0000:01:00.1: Multiqueue Enabled: Rx Queue count = 8, Tx Queue count = 8
[ 5.257618] ixgbe 0000:01:00.1: PCI Express bandwidth of 32GT/s available
[ 5.266373] ixgbe 0000:01:00.1: (Speed:5.0GT/s, Width: x8, Encoding Loss:20%)
[ 5.275593] ixgbe 0000:01:00.1: MAC: 2, PHY: 1, PBA No: E66560-005
[ 5.284928] ixgbe 0000:01:00.1: 90:e2:ba:19:f7:51
[ 5.294438] ixgbe 0000:01:00.1: Intel(R) 10 Gigabit Network Connection
[ 5.307355] ixgbe 0000:01:00.1 p1p2: renamed from eth1
[ 5.341594] ixgbe 0000:01:00.0 p1p1: renamed from eth0
[ 13.168592] ixgbe 0000:01:00.0: registered PHC device on p1p1
[ 13.348951] ixgbe 0000:01:00.0 p1p1: detected SFP+: 5
[ 13.612919] ixgbe 0000:01:00.0 p1p1: NIC Link is Up 10 Gbps, Flow Control: RX/TX